Manufacturer : Seagate
Model : ST305004EXA101-RK
ASIN : B001SJVU6K
Price : 82.99$
Last Price : 53$(Discount 36.1368839619231%
See Special Offers
Product DescriptionSeagate USB 2.0 External Hard Drive ST305004EXA101R Hard Drives - External
490 of 507 people found the following review helpful:
Stay far far away, Major flaw with Seagate Expansion series.
The symptom:
Drive works fine for the first few GB's, and once it gets somewhere around 50 to 300 GB, it starts making loud clicking noise. The more data added to the drive the more frequent the clicking noise become and eventually the drive fails.
Analysis:
As the first few sectors of the platter / platters, the traveling distance (from the edge of palter to the center) for the head arm is not that great. But as more data gets written to the disk, inner sectors of platters gets occupied with data. That's when the problem starts.
Without going into technical details, the issue here is not the drive. It is the PCB (Printed Circuit Board) that is installed in these external enclosures. This board regulates & provide power to the drive and in simple terms, there is not enough power for the disk to spin and for the head arm to extend far to reach inner sectors of the platter / platters .
I have tried many solutions recommended on the internet, including a youtube video posted by a person identified in this video as Bruce. None has worked. Some others suggested to change the usb cable, others suggested a firmware upgrade, some suggested to send the drive back to Seagate for replacement. Some people has done that but they got a new replacement drive that did the same clicking noise, and had to be sent back again. Do not waste your time on these suggestions, because I have tried them all before I started looking & analyzing the problem myself.
Seagate is well aware of this issue, but not only they are down playing the extent of this problem, they continue to sell these defective external boxes. In fact the first time this issue was reported on Seagate forum was 06-19-2009 06:50 AM. Up to the writing of this review, there are more than 31 pages from thousands of people reporting the issue with clicking noise & drive failure on Expansion boxes.
Solution & your options:
1 - If you just bought an Expansion, return it while you can get your money back.
2 - If it is under warranty, do not return it to Seagate. If you do, you end up with another defective drive that you have to send back again & each time cost $15.00 to $30.00 just for shipping (inside U.S.). Do one of the following:
A) Buy a new non-Seagate external enclosure (many good brand are in the market between $14.00 to $39.00). Take the drive out of Seagate Expansion enclosure and place it on the new one (this may void your warranty, but it is a permanent fix). Yes, You have break the tabs to open it. Seagate purposely made it non-serviceable.
B) If you can find a PCB that matches the Seagate Expansion box power & USB port openings, replace the PCB.
In my case, I replaced the case with a new enclosure.
C) Never buy a Seagate drive. They have been less than sincere & straight forward with their customers & continue to sell a defective product that they are well aware of it.
228 of 253 people found the following review helpful:
Seagate Expansion: Couldn't stand it even for a day
Upon calling Seagate, the technician warned me that the drive was probably in its death throes and to make sure I had a backup of anything on it. I put the product back in its box, and sent it back to Amazon, who issued a replacement.
When the replacement arrived, all seemed well at first. It formatted just fine, and seemed quiet and elegant. Once I connected it to my primary machine and began to copy data, however, it began making a similar noise to the prior model. Though it showed no signs of failure, the drive was so loud that I became annoyed with it quickly and called Seagate again. A representative, who was very helpful, had me run the SeaTools diagnostic tool, which passed. After I held the phone to the drive, however, he understood why it was so bothersome to me but couldn't explain what the noise was. He did state that the 1.5TB drives are often louder than other drives due to the additional platters required in the drive, but not to the extent I experienced.
Needless to say, I called Amazon this past afternoon, and the representative I spoke with was very understanding. When I detailed the issue and he heard the drive, he was glad to create an RMA, citing on the ticket that the drive "sounds like a jet engine revving up."
Though I've been very negative about this product, it does have its merit. When operational, it was quick to copy data (~15-20MB/s). It also has a very elegant profile, which looked wonderful on my desk; the small green LED on the front was a wonderfully unobtrusive drive activity indicator. Finally, it was preformatted as NTFS and included no unnecessary software, which was a refreshing change from many other external hard drives.
In short, this drive (at least the 1.5TB model) is worth consideration if noise is not a factor, however I have doubts to its longevity.
231 of 258 people found the following review helpful:
Works great on my Mac - I've always been satisfied with Seagate and this is a great price and great quality
For comparison, I tried moving a 2.15 GB video file back and forth between my laptop's hard drive and a few of my external drives. This one was fastest at both downloads and uploads - it would download the 2.15 GB file in one minute, 17 s. as opposed to 1 min., 40 for the portable FreeAgent Go and 1 min., 37 for the Western Digital. Uploading results were similar: it would upload the same 2.15 GB video file in 1 minute, 10 s. while the other drives uploaded in about 1 minute, 20 s. So, it's pretty fast and does exactly what I need - I've got no complaints and am very happy about the price (which turns out to be almost exactly what I paid a year or so ago for my 320GB portable drive and much less than what I paid about 3 years ago for my 500 GB desktop drive). What's not to like?
One more thing, for Mac users. While this drive is set up out of the factory to plug and play on Windows it can easily be converted to a handy Mac drive. Here's how:
1. plug it in to your Mac, using the USB 2.0 cable provided with the drive
2. open up your applications folder, search for the utilities folder and then run "disk utility" (or, just search for "disk utility" in finder or spotlight and click on it).
3. you should see an icon for your "1 TB Seagate Desktop Media" drive in the left column of "disk utility" and also a drive partition (as I recall it was called "desktop" but I changed the name) underneath that.
4. click on the icon labelled "1 TB Seagate Desktop Media" and you'll see a few options in the window; click "partition"
5. after this steps will vary depending on what you want to do with this. For what I wanted, I decided to create two partitions on my hard drive. So, under "volume scheme" I selected "2 partitions" then clicked on the top one and set it to 250 GB and that left 750.10 GB on the other one. For the "format" I selected "Mac OS X Extended" but you'd want to select the journaled option if you want to use either of these drives as a "boot disk". I didn't. Then hit "apply" and it will erase everything on the disk and break it into two sections.
Now when you plug in the hard drive two icons will appear on your desktop, as if there were two separate external drives. I use the smaller one for regular backups and the larger one for storing all of my old video files. I'm sure there are lots of other ways to get an excellent value from this sleek and handy little drive. Enjoy!
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment